[aspect-devel] Number of grouped files = 1 -> code doesn't exit after it's finished

[Timo Heister]

Hey Jacky,

the example is working here.

Grouping of files will use MPI I/O, so the problem can be related to
the filesystem you are writing to (is it an NSF, parallel file system,
or a normal local directory?). Also, what MPI library are you using?




On Sat, Mar 19, 2016 at 5:06 PM, Austermann, Jacqueline
<jaustermann at fas.harvard.edu> wrote:
> Hi,
>
> After updating my master with the upstream master I’ve been running into the
> following problem: When I set Number of grouped files in subsection
> Postprocess, subsection Visualization to 1 (and probably to anything other
> than 0) the code runs through without problems till the end (after it prints
> the table with the different run times) but does then not exit. It just
> hangs and I can cancel it manually with the right output but if I don’t do
> that it just stays there until the runtime for the submitted run is
> exceeded. I tried this out with a few cookbooks and always had the same
> problem (I attached a .prm that produces this error).
> Let me know if you have any ideas why this could be.
>
> Thanks!
> Jacky
>
>
>
>
> _______________________________________________
> Aspect-devel mailing list
> Aspect-devel at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/aspect-devel



-- 
Timo Heister
http://www.math.clemson.edu/~heister/