[cig-commits] r20603 - seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL
dkomati1 at geodynamics.org
dkomati1 at geodynamics.org
Mon Aug 20 06:41:34 PDT 2012
Author: dkomati1
Date: 2012-08-20 06:41:33 -0700 (Mon, 20 Aug 2012)
New Revision: 20603
Modified:
seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.pdf
seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.tex
Log:
improved the sentence about mcmodel=medium
Modified: seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.pdf
===================================================================
(Binary files differ)
Modified: seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.tex
===================================================================
--- seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.tex 2012-08-20 13:24:39 UTC (rev 20602)
+++ seismo/3D/SPECFEM3D/trunk/doc/USER_MANUAL/manual_SPECFEM3D.tex 2012-08-20 13:41:33 UTC (rev 20603)
@@ -329,7 +329,7 @@
of processors, the memory size needed on each processor might become
greater than 2 gigabytes, which is the upper limit for 32-bit addressing.
In this case, on some compilers you may need to add \texttt{``-mcmodel=medium}'' or \texttt{``-mcmodel=medium -shared-intel}''
-to the compiler options of CFLAGS, FCFLAGS and LDFLAGS otherwise the compiler will display an error
+to the configure options of CFLAGS, FCFLAGS and LDFLAGS otherwise the compiler will display an error
message (for instance \texttt{``relocation truncated to fit: R\_X86\_64\_PC32 against .bss''} or something similar);
on an IBM machine with the \texttt{xlf} and \texttt{xlc} compilers, using \texttt{-q64} is usually sufficient.\\
@@ -887,7 +887,7 @@
\includegraphics[width=.6\textwidth]{figures/workflow.jpg}
\par\end{centering}
-\caption{Schematic workflow for a SPECFEM3D simulation. The exectable \texttt{xgenerate\_databases} creates the GLL mesh points and assigns specific model parameters.}
+\caption{Schematic workflow for a SPECFEM3D simulation. The executable \texttt{xgenerate\_databases} creates the GLL mesh points and assigns specific model parameters.}
\label{fig:workflow.databases}
\end{figure}
More information about the CIG-COMMITS
mailing list