[CIG-SEISMO] SPECFEM3D - Problem with creating topography with mesh_mount.py

[Shahar Barak]

Cubit ver 13.2. File attached.

Thanks!

Shahar



On Sun, Jul 7, 2013 at 9:43 AM, emanuele casarotti <
emanuele.casarotti at gmail.com> wrote:

> Can you show your journal file and the version of cubit that you are using?
>
> Emanuele
>
> Il giorno 07/lug/2013, alle ore 17:45, Shahar Barak <shaharb at stanford.edu>
> ha scritto:
>
> Hi,
>
> I'm using mesh_mount.py from the Mount St Helens example in SPECFEM3D to
> create a mesh with topography, but at a different location.
> The problem is that after the Imprint All command the volume
> isn't separated into the above topography and below topography. I don't get
> any error messages.
> Does anyone have experience with this? Any ideas what might be the problem?
> Is it possible that the problem is that the topography at the edges it to
> rugged?
>
> Thanks,
>
> Shahar
>
>
> Shahar Barak
> =======================================
> Crustal Geophysics Research Group
> Department of Geophysics, Stanford University
> 397 Panama Mall, Stanford CA 94305-2215
> Mitchell Building, room 463
> Office: (650) 725 8229
> Cell: (650) 276 6169
> shaharb at stanford.edu*
> *
>
> _______________________________________________
> CIG-SEISMO mailing list
> CIG-SEISMO at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-seismo
>
>
> _______________________________________________
> CIG-SEISMO mailing list
> CIG-SEISMO at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-seismo
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://geodynamics.org/pipermail/cig-seismo/attachments/20130707/e21b2efb/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: create_mesh.py
Type: application/octet-stream
Size: 8155 bytes
Desc: not available
URL: <http://geodynamics.org/pipermail/cig-seismo/attachments/20130707/e21b2efb/attachment-0001.obj>