[CIG-SHORT] pylith - multiple faults
Brad Aagaard
baagaard at usgs.gov
Wed Sep 19 08:06:01 PDT 2007
Chris-
I found the error in your parameters. You did not specify the id for either of
the faults, so it issued the default value for each one. Because the fault BC
is applied based on the id (which is an integer, while the label is a text
string), the fault parameters were applied to both of the faults.
This is documented in the manual (note the last sentence):
id This is an integer identifier for the fault surface. It is used to specify
the material-id of the cohesive cells in the mesh. Material identifiers must
be unique so this value cannot be the same as any of the material models or
any other fault.
Brad
More information about the CIG-SHORT
mailing list