[CIG-SHORT] difference between figures

[Brad Aagaard]

FingLi-

To see the fault slip, you need to use the warp filter in ParaView with 
an exaggeration. The figures you included show the correct displacement 
field when the warp filter is not used.

Brad


lf1981 at mail.ustc.edu.cn wrote:
> Dear sir:
>       I had run the examples of pylith under the dircetory of  
> $Home/pylith-1.3.0/examples/twocells/twotri3,when I run the Axial displacement
> example and sheardisplacement example,the figures which I obtained coincide with
> the    axialdisp.jpg and sheardisp.jpg that contained in the directory very
> well.But when I run Kinematic Fault Slip Example, there was slight difference
> between the generated figure and the dislocation.jpg.I can't distinguish the fault
> slip which defined 0.01m in the dislocation_slip.spatialdb in the generated
> figure. I also compared the generated dislocation figures using Two
> Quadrilaterals,Two Tetrahedra,etc.with the standard dislocation.jpg, the result
> was the same ,no fault slip. I had put the generated dislocation figures in the
> attachment.can you give me some advice ? Thank you very much .
>                                               Sincerely FengLi 
> 
> 
> 
> 
> ------------------------------------------------------------------------
> 
> 
> ------------------------------------------------------------------------
> 
> 
> ------------------------------------------------------------------------
> 
> 
> ------------------------------------------------------------------------
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-short