[CIG-SHORT] Pylith problem

[Brad Aagaard]

This error shows up when there are inconsistencies in setting up the 
fault from the group of vertices. I suspect that the vertices you 
selected for fault 'f001' do not correspond to an interior surface. Make 
sure the group of vertices corresponds to a simply connected surface (no 
holes or gaps) and that each cell has only one face (3-D) or edge (2-D) 
on the fault.

Regards,
Brad Aagaard

On 09/24/2013 01:16 AM, 范清彪 wrote:
> Hi
>     I am using Pylith to simulate earthquake postseismic deformation. A problem occurs:
>
>           RuntimeError: Error occurred while adjusting topology to create cohesive cells for fault 'f001'.
>           Cannot handle partially interpolated meshes
>
>    I don't known what the problem is with the meshes.
>    Please help.
>    Thanks and regards.
> Qingbiao Fan
>
>
>
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>