[CIG-SHORT] Q8 Elements can't run in Pylith
Charles Williams
willic3 at gmail.com
Fri May 23 00:26:51 PDT 2014
Hi Xiao,
The Q8 element isn’t yet implemented in PyLith, although it should be available in an upcoming release. At present, only linear elements are supported.
Cheers,
Charles
On 23/05/2014, at 6:48 pm, Ma, Xiao <xiaoma5 at illinois.edu> wrote:
> Hi,
> I figure out how to implement Q8 element in Trelis, however after I generate the mesh with Q8 elements, the Pylith gives the error 'Topology can't for cohesive cell' , I used to run with Q4 elements just fine, is this because of the addition nodes on the edges? Should I change something in the cohesive formulation?
> Thank you
> Xiao
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
Charles A. Williams
Scientist
GNS Science
1 Fairway Drive, Avalon
PO Box 30368
Lower Hutt 5040
New Zealand
ph (office): 0064-4570-4566
fax (office): 0064-4570-4600
C.Williams at gns.cri.nz
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20140523/afdccf77/attachment.html>
More information about the CIG-SHORT
mailing list