[CIG-SHORT] Output error with cohesion on faults

[Joseph McCosby]

Hello,


I've run into a bit of a problem when I apply cohesion to a fault. The displacement output is "wonky". I'm working in a 2D environment, and with cohesion on a fault, the fault blocks begin to overlap, and their displacement magnitude jumps from active at one time step, to the opposite direction in the next. Is there a reason this is happening? When my fault cohesion is 0.0*MPa, this error does not occur.


Thank!

Joseph "Bodie" McCosby

Clarion University of PA

Undergraduate Student

Dept. Biology & Geosciences

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20160222/3d9a1f65/attachment.html>