[CIG-SHORT] pressure & pylith

[Brad Aagaard]

Alberto,

At the beginning of a PyLith simulation, you can specify initial 
stresses. I don't know if this is sufficient for your needs.

Regards,
Brad


On 10/17/16 11:17 PM, Cominelli Alberto wrote:
> Dear Brad Aagaard,
>
> I am willing to use Pylith for some couple fluid-flow/geomechanical
> simulations. In my case I want to run a fluid flow simulator first and
> then pass pressure on an element basis to Pylith in a one-way mode.
>
> I wonder if this  possible with the current pylith versions w/o
> modifying the code. I am digging in the documentation but so far I could
> not find a way.
>
> Looking forward to hearing from you soon I thank you in advance for any
> hints.
>
> Regards,
>
> Alberto.
>
>
>
>
> *Eni* SpA
> Sede Legale
> Piazzale Enrico Mattei, 1
> 00144 Roma - Italia
>
> Capitale sociale
> euro 4.005.358.876,00 i.v.
> Codice Fiscale e Registro Imprese di Roma n. 00484960588
> Partita IVA n. 00905811006
> R.E.A. Roma n. 756453
>
> Sedi secondarie:
> Via Emilia, 1 e Piazza Ezio Vanoni, 1
> 20097 San Donato Milanese (Milano) – Italia
>
> eni.com <http://www.eni.com>
>
> ------------------------------------------------------------------------
> Message for the recipient only, if received in error, please notify the
> sender and read http://www.eni.com/disclaimer/