[CIG-SHORT] Output for failure

[Brad Aagaard]

Ekaterina,

You can request output of the plastic strain state variable and then do 
post processing (for example, use the Threshold filter in ParaView) to 
see where it is nonzero.

Regards,
Brad


On 02/21/2017 06:50 AM, Ekaterina Yevgenyevna Bolotskaya wrote:
> Dear all,
>
> Is there a way in Pylith to explicitly output for regions where material
> has failed?
> I have Drucker-Prager elastoplastic material.
>
> Thanks!
>
>
> Best regards,
> Ekaterina Bolotskaya
>
> PhD in Geophysics,
> Earth, Atmospheric and Planetary Science Department,
> Massachusetts Institute of Technology
> E-mail. bolee at mit.edu
> Mob. +1 (857) 284-2805 <tel:%2B1%20%28857%29%20284-2805>
>          +7 (963) 995-36-33 <tel:%2B7%20%28963%29%20995-36-33>
>
>
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>