[CIG-SEISMO] SPECFEM3D Globe Problem

[Dimitri Komatitsch]

Hi,

 From the content of job.o it seems that you are running out of memory, 
but I am not sure. What you can do is try with fewer seismic recording
stations in DATA/STATIONS (e.g., keep three or four stations only to see 
what happens).

Best regards,
Dimitri.

On 09/24/2010 07:21 PM, J.Weston at uea.ac.uk wrote:
> Hi
>
> I have just had a chat with one of your SPECFEM3D globe experts who gave a
> practical at the QUEST workshop in Sardinia and he suggested emailing my
> errors to you guys.
>
> So I am just trying to forward model CMT source parameters and have
> managed to successfully run a simulation for a record length of 10
> minutes. But when I try to run it for a 50 minute record length for the
> same source parameters I get quite a few errors, so I have attached the
> job.o file. I would copy and paste them but there are over 2000 lines! I
> think it may be to do with the compiler but at the same time I am also
> probably doing something wrong. So any advice/help would be greatly
> appreciated!
>
> Thanks
>
> Jennie Weston
>
> PhD
> Department of Environmental Sciences
> University of East Anglia
> Norwich
> NR4 7TJ
> UK
>
>
>
> _______________________________________________
> CIG-SEISMO mailing list
> CIG-SEISMO at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-seismo

-- 
Dimitri Komatitsch - dimitri.komatitsch aT univ-pau.fr
Professor, University of Pau, Institut universitaire de France,
CNRS and INRIA Magique3D, France   http://www.univ-pau.fr/~dkomati1