[CIG-SEISMO] Installation of SPECFEM3D

[Jeong, Chanseok]

Hi there,

I am trying to install SPECFEM3D. I ran into an error message even from the first step of the installation procedure.
I typed the following command.
./configure FC=ifort MPIFC=mpif90
Then, there came up error message: “MPI header not found” as follows.

[https://lh6.googleusercontent.com/W14oVjNQu6LHthnnNdnvOlEAKwXPcq2uOe_8KHQJWYIpR41-6qHPOloVtSgyjA-JUPFMSyZpKvkDrAfSvOU-f8JduYif49gFZ6Ul8p6_-hntkFUWsTD8QMGWnz3LuyKRzZREvaM]


Could you let me know how to address this problem?

Thank you very much.

Sincerely,



------------------------------------
Chanseok Jeong, Ph.D.
------------------------------------
Assistant Professor,
Department of Civil Engineering,
The Catholic University of America,
620 Michigan Avenue, N.E.,
Washington, DC, 20064.

Room number: Pangborn Hall G-18
Office: (202)319-6672
Fax:     (202)319-6677
Email: jeong at cua.edu
http://faculty.cua.edu/jeong