[CIG-SEISMO] Installation of SPECFEM3D

[Dimitri Komatitsch]

Hi Chanseok Jeong,

Very likely MPI is not installed on your machine or is not in your $PATH 
variable (in your .bash_profile or .cshrc file)

Best regards,
Dimitri.


On 06/07/2015 03:01 AM, Jeong, Chanseok wrote:
> Hi there,
>
> I am trying to install SPECFEM3D. I ran into an error message even from the first step of the installation procedure.
> I typed the following command.
> ./configure FC=ifort MPIFC=mpif90
> Then, there came up error message: “MPI header not found” as follows.
>
> [https://lh6.googleusercontent.com/W14oVjNQu6LHthnnNdnvOlEAKwXPcq2uOe_8KHQJWYIpR41-6qHPOloVtSgyjA-JUPFMSyZpKvkDrAfSvOU-f8JduYif49gFZ6Ul8p6_-hntkFUWsTD8QMGWnz3LuyKRzZREvaM]
>
>
> Could you let me know how to address this problem?
>
> Thank you very much.
>
> Sincerely,
>
>
>
> ------------------------------------
> Chanseok Jeong, Ph.D.
> ------------------------------------
> Assistant Professor,
> Department of Civil Engineering,
> The Catholic University of America,
> 620 Michigan Avenue, N.E.,
> Washington, DC, 20064.
>
> Room number: Pangborn Hall G-18
> Office: (202)319-6672
> Fax:     (202)319-6677
> Email: jeong at cua.edu
> http://faculty.cua.edu/jeong
> _______________________________________________
> CIG-SEISMO mailing list
> CIG-SEISMO at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-seismo
>

-- 
Dimitri Komatitsch
CNRS Research Director (DR CNRS), Laboratory of Mechanics and Acoustics,
UPR 7051, Marseille, France    http://komatitsch.free.fr