[CIG-SHORT] 3D fault slip

[Charles Williams]

Hi Yaru,

It would help to see your .cfg files.  That might show what is going on.

Cheers,
Charles


On Oct 20, 2008, at 9:31 PM, yaru wrote:

> Dear PyLith Developers/Users,
>
>
>   I've tried to specify fault slip at few hundred points on the  
> fault (see
> attached file). No mater what I do, the fault slip is always  
> uniform. Any
> idea?
>
> Thanks,
>
> Yaru
>
>
> ****************************************************
> Ya-Ju Hsu
> Institute of Earth Sciences, Academia Sinica
> 128 Academia Road, Sec. 2, Nankang,
> Taipei 115, TAIWAN
> e-mail: yaru at earth.sinica.edu.tw
> Tel: 886-2-27839910 ext. 415
> Fax: 886-2-27839871
> ****************************************************
>
>
>
> <finalslip2.spatialdb>_______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-short

Charles A. Williams
Scientist
GNS Science
1 Fairway Drive, Avalon
PO Box 30368
Lower Hutt  5040
New Zealand
ph (office): 0064-4570-4566
fax (office): 0064-4570-4600
C.Williams at gns.cri.nz
NOTE NEW E-MAIL ADDRESS

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://geodynamics.org/pipermail/cig-short/attachments/20081021/f8532ac4/attachment.htm