[CIG-SHORT] static friction and cohesion on fault (2D)
Brad Aagaard
baagaard at usgs.gov
Thu Nov 8 17:30:09 PST 2012
Bobby,
I suggest plotting the traction time histories on the fault. You should
behavior consistent with the fault constitutive model and parameters you
are choosing.
Regards,
Brad
On 11/8/12 5:09 PM, BOK10 at pitt.edu wrote:
> I have a 2D model with a fault that I have static friction and cohesion
> on, but no matter what friction (0-1) or cohesion (0-200 kpa) estimates I
> pick, the slip rates along the fault are identical and occur in the same
> exact time-step. I am pushing the blocks past one another by applying
> velocity boundary conditions. I didn't have this problem before until I
> changed the geometry of my faults slightly. Is there something else that
> could be causing this?
>
> Bobby
>
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>
More information about the CIG-SHORT
mailing list