[CIG-SHORT] Fault direction in 3D fault
Charles Williams
willic3 at gmail.com
Thu May 1 16:25:25 PDT 2014
Hi Jiangzhi,
One problem that I see is that I think you’ve mixed up the bc_dof for your bottom boundary (should be 2) compared to your front and back boundaries (should be 1). Let me know if this helps.
Cheers,
Charles
On 2/05/2014, at 10:26 am, Jiangzhi Chen <jzchenjzarthur at gmail.com> wrote:
> Hi everyone,
>
> I have a 3D subduction model simulating the interseismic deformation, where I have both fault_slabtop and fault_slabbot creeping. I have set fault_slabtop with reverse_slip of 8 cm/yr and fault_slabbot with reverse_slip of -8 cm/yr, and used the up_dir parameter [0,0,1], but still the subduction is in wrong direction. I am not sure what is wrong. The configuration files are attached. Thanks.
>
> Jiangzhi
> <screen.png><pylithapp.cfg><interseismic.cfg><mat_conmantle.spatialdb><mat_oceanlitho.spatialdb><mat_oceanmantle.spatialdb><mat_conlitho.spatialdb>_______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
Charles A. Williams
Scientist
GNS Science
1 Fairway Drive, Avalon
PO Box 30368
Lower Hutt 5040
New Zealand
ph (office): 0064-4570-4566
fax (office): 0064-4570-4600
C.Williams at gns.cri.nz
More information about the CIG-SHORT
mailing list