[CIG-SHORT] number of points in output file
Brad Aagaard
baagaard at usgs.gov
Tue May 27 12:14:07 PDT 2014
Xiao,
Use the HDF5 utility h5dump to examine the contents of the HDF5 file.
http://www.hdfgroup.org/HDF5/doc/RM/Tools.html#Tools-Dump
This will allow you to examine the sizes and values of each of the fields.
Regards,
Brad
On 05/27/2014 12:09 PM, Ma, Xiao wrote:
> Hi,
> I have this problem ,I have two model, all in 2D, it is a 25 km long fault ,first mode,I discrete it with 12.5 m mesh ,second model,I discrete it with 50m mesh, however the output file that show the .fault which show the slip, slip rate , traction, using Paraview, I turn on the makers on the plot along a line, and find out the two case have the same number of output points, in other words ,they have the same number of makers, shouldn't the 12.5m mesh case have twice the number of points for the 25m case ?
> Best wishes,
> Xiao
>
>
>
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>
More information about the CIG-SHORT
mailing list