[CIG-SHORT] Question
Li, Teng
tengli2 at illinois.edu
Tue Apr 18 20:57:49 PDT 2017
Hi Brad,
Thanks for the suggestions of the edge. This really helps me.
And I do not specify quad_oder on the command line. I only use it in the material part, fault part and boundary part as we can see from the code.
Best,
Teng
Teng Li
Master Candidate in Structures
Department of Civil and Environmental Engineering
University of Illinois at Urbana-Champaign
205 North Mathews Ave, Urbana, IL. 61801
Phone:(217)8196210, Email: tengli2 at illinois.edu
________________________________________
From: CIG-SHORT [cig-short-bounces at geodynamics.org] on behalf of Brad Aagaard [baagaard at usgs.gov]
Sent: Tuesday, April 18, 2017 9:58 PM
To: cig-short at geodynamics.org
Subject: Re: [CIG-SHORT] Question
On 4/18/17 8:50 PM, Li, Teng wrote:
> Hi,
> I have a question about quadrature.cell.quad_order. In my case, I have a
> main fault and a secondary fault. And these 2 faults meet at one node. I
> create a nodeset named fault_edge for this edge. And in the .cfg file. I
> write edge=fault_edge only in the fault1 part, which is the
> secondary fault. Should I also write edge=fault_edge in the fault part?
You should use edge = NODESET_NAME with each fault that has buried edges
(where NODESET_NAME is the name of the nodeset with the nodes on all
buried edges for that fault), that is, edges that end inside the domain.
Faults in which the all edges are at boundaries of the domain are the
only faults that do not need to use edge = NODESET.
> And also, after running the code, I get the *_error:_*
>
>
>
>>> {command line}::
>
> >> pyre.inventory(error)
>
> -- 'quadrature.cell.quad_order'
>
> pylithapp: configuration error(s)
I am not sure why you are seeing this. The error message seems to
indicate you have specified the quad_oder on the command line.
Regards,
Brad
_______________________________________________
CIG-SHORT mailing list
CIG-SHORT at geodynamics.org
http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
More information about the CIG-SHORT
mailing list