[CIG-SHORT] question about overlapping node in different faults

[Charles Williams]

I’m not sure if this is your problem, but in the text below you misspelled ‘friction’ when defining SlipWeakening.  It would help to see your entire .cfg file, along with the entire error message.

Cheers,
Charles


> On 30/03/2017, at 1:50 PM, Li, Teng <tengli2 at illinois.edu> wrote:
> 
> Hi,
> I created 2 faults, and they intersect at one node. And then I create a group name "inter" and add this node. Then I create anodeset named "inter" and add the above group. Finally, in the script, I did in this way:
> interfaces=[fault,fault1]
> And I put
>  edge=inter 
> for both fault and fault1.
> 
> And in the script, I used:
> friction= pylith.frition.SlipWeakening
> friction.label = Slip weakening
> for both fault and fault1.
> 
> After running, I get the error message:
> pyre.inventory (error)
>  -- 'friction.label'
> 
> 
> 
> Teng Li
> 
> Master Candidate in Structures
> 
> Department of Civil and Environmental Engineering
> 
> University of Illinois at Urbana-Champaign
> 
> 205 North Mathews Ave, Urbana, IL. 61801
> 
> Phone:(217)8196210, Email: tengli2 at illinois.edu <mailto:tengli2 at illinois.edu>
> 
> 
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org <mailto:CIG-SHORT at geodynamics.org>
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short <http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short>
Charles Williams I Geodynamic Modeler
GNS Science I Te Pῡ Ao
1 Fairway Drive, Avalon 5010, PO Box 30368, Lower Hutt 5040, New Zealand
Ph 0064-4-570-4566 I Mob 0064-22-350-7326 I Fax 0064-4-570-4600
http://www.gns.cri.nz/ <http://www.gns.cri.nz/> I Email: C.Williams at gns.cri.nz <mailto:your.email at gns.cri.nz>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20170330/f00cace7/attachment.html>