[CIG-SHORT] fault edge motion
Brad Aagaard
baagaard at usgs.gov
Wed Oct 25 08:26:14 PDT 2017
Huihui,
I do not know what you mean by "two adjacent planar faults". Are the
faults parallel? perpendicular? Do they intersect? Please send a diagram
of your fault geometry and indicate which edges you marked as buried
fault edges.
Thanks,
Brad
On 10/25/2017 02:25 AM, Huihui Weng wrote:
>
> Dear all,
>
> I tried to build a model with two adjacent planar faults, one is kinematic fault and the other is dynamic fault. The PyLith of new version requires me to provide the fault edge, i.e., the group of nodes in the line that connects the two faults. But I find the fault edge always keep fixed. How can I set up the model to make the fault edge move to fill the “gap” of slip between these two faults? It does seem it is OK for 2D models of older Pylith versions. Thanks.
>
> Best regards,
> Huihui
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>
More information about the CIG-SHORT
mailing list