[CIG-SHORT] How to make the surface cells smaller

[xu bei]

Hello, Brad,

Yes, it is running out of memory. I use a coarser cell size (500m) on the fault, but I end up with some very coarse surface cells. such as



[cid:8a4f2d98-5cfd-4cc9-bbf6-a1e0260ce84b]



However, What I want is like this:



[cid:513d046d-8928-428c-bb64-39ce344d747d]



>From the fault plane, the grid gradually becomes bigger.


I tried to mesh the boundary line along different paths, but  I still end up with some very coarse surface cells. I do not know why. Do you know why? Would you like to give some suggestions?


By the way, how to output the value of  a variable.

For example,

# dxA - size at vertex 13
#{dxStart=dx}{curveL=Length(58)}{execute("dxA="//fun_dx)}


If I want to know the value of the variable "dxA", what should I do?


Best regards,


Bei Xu






-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20180504/94bb3176/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: pastedImage.png
Type: image/png
Size: 52656 bytes
Desc: pastedImage.png
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20180504/94bb3176/attachment-0002.png>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: 1.png
Type: image/png
Size: 108325 bytes
Desc: 1.png
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20180504/94bb3176/attachment-0003.png>