[CIG-SHORT] GeoFEST runs for strike-slip model

[Jiangning Lü]

Hello,

I'v made GeoFEST input files for strike-slip model, and I'm trying to run them
on parallel cluster. The 1km resolution file goes well, and I've put the input
file and output results on CIG website.
There is an error when running 500m resoluton case.
when I executed the command: gfmeshparse  to make the *.jpl file from geofest
input file, an error occured:
 "cycling.  . .
  cycling.  . .
 Displacement Data...
 Element Data...
 Material Data...
 Node Data...
 Data Loading Complete...
 Edge Numbering Assigned...
 Face Numbering Assigned...
Segmentation fault
"
   I've checked the file many times, the 500m resolution file is made the same
as 1km resolution file except resolution. The 1km file goes well, but 500m file
does not.  I've put the 500m input file on the website.

   Because I couldn't run it on parallel cluster, I tried to run it on my pc. It
took more than 14 hours to stop at the messaage:" calling solver...", I have to 
 kill it...

could someone knowing the geofest give me a hint what's the problem?

For the 250m resolution case,  I'm also trying to made the GeoFEST input files,
I've using several matlab codes to made the input file from lagrit mesh and
boundary conditions. Because of the huge node number, it usually took more than
10 hours to run the matlab codes on my pc.
If someone have the 250m resolution GeoFEST input files already, I could run
them on the  Parallel cluster.

Best,
Jiangning
EAPS,MIT