[CIG-SHORT] Problem installing nemesis

[Laura Alisic]

Hi,

I am in the process of installing PyLith 1.0.1 from source on a linux  
machine (32-bit). So far I have installed all dependencies of PyLith,  
apart from nemesis. During configuration of nemesis, it doesn't seem  
to be able to find the MPI library, despite the fact it's being  
called in the configure command I used. Also, it's set in my .cshrc  
file in $LD_LIBRARY_PATH.

My $LD_LIBRARY_PATH looks as follows:
stapi% echo $LD_LIBRARY_PATH
/home/alisic/Snac/build/lib:/home/alisic/StGermain/StGermain/build/ 
lib:/home/alisic/opt/petsc-dev/lib/linux_g++_debug:/home/alisic/opt/ 
petsc-dev/linux_g++_debug/lib

The MPI lib directory contains the following:
stapi% ls /home/alisic/opt/petsc-dev/linux_g++_debug/lib
libchaco.a         libmpich.a           libmpich.so@        
libpetsccontrib.so*  libpetscmat.a     libpetscts.a
libfmpich.a        libmpichcxx.a        libmpich.so.1@      
libpetscdm.a         libpetscmat.so*   libpetscts.so*
libfmpich.so@      libmpichcxx.so@      libmpich.so.1.1*    
libpetscdm.so*       libpetscsnes.a    libpetscvec.a
libfmpich.so.1@    libmpichcxx.so.1@    libpetsc.a          
libpetscksp.a        libpetscsnes.so*  libpetscvec.so*
libfmpich.so.1.1*  libmpichcxx.so.1.1*  libpetsccontrib.a   
libpetscksp.so*      libpetsc.so*      mpich2-ch3.pc

The config.log is attached.

How could I go about solving this issue? I've been trying several  
configure options without success.
Any help would be greatly appreciated!

Thanks,
Laura


===============================
     Laura Alisic
     ----------------
     PhD Student in Geophysics
     Seismological Laboratory
     California Institute of Technology			
     alisic at gps.caltech.edu
     www.gps.caltech.edu/~alisic			
===============================



-------------- next part --------------
Skipped content of type multipart/mixed