[CIG-SHORT] Mesh-generation and processing question

[BOK10 at pitt.edu]

Hi,

So, I'm trying to replicate step 12 (7.8.7.4 in the PyLith Manual) with a
more complex model (in 2-D, not 3-D), but I'm unsure of how to proceed.
Any guidance would be greatly appreciated.

I'm making my mesh in Cubit, and I'm trying to have three faces (upper
bound - fixed, middle bound - 10 mm/yr west, and lower bound - 17 mm/yr
west). I've attached an image of my 2-D model. I can get all my meshes to
create just fine, but when I create nodesets the middle bound will show up
as a nodeset, but no nodes will highlight when I click on it.

My question(s) are: Is it possible to set up the mesh as I have done? If
not, can someone suggest an alternate way to go about this?

Thanks,
Bobby Karimi
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Model.jpg
Type: image/jpeg
Size: 28679 bytes
Desc: not available
Url : http://geodynamics.org/pipermail/cig-short/attachments/20120710/397d3f53/attachment-0001.jpg