[CIG-SHORT] Compiling pylith-2.1.0 using pylith 2.2.0 installer

[Matthew Knepley]

On Sun, Jul 2, 2017 at 8:56 PM, Ehsan Haghighat <ehsanh at mit.edu> wrote:

> Hi Brad,
>
> I am trying to install the pylith 2.1.0 from the 2.2.0 installer. The
> reason is that it makes it easier to merge some libraries that’s been
> developed earlier in 2.1.0 to be merged later to the 2.2.0. After setting
> up the configuration file, I change the Makefile’s PYLITH_VER parameter to
> 2.1.0. However, the installer stops at very end during compiling pylith
> with following error message:
>

It looks like it stops during configure here. Sending config.log would help
us diagnose the problem.

  Thanks,

    Matt


> ——
> checking for PETSc config... no
> configure: error: PETSc config dir not found; check PETSC_ARCH
> make[2]: Entering directory `/home/ehsanhaghighat/
> development/pylith-gprs/build/pylith/pylith-build'
> make[2]: *** No targets specified and no makefile found.  Stop.
> make[2]: Leaving directory `/home/ehsanhaghighat/
> development/pylith-gprs/build/pylith/pylith-build'
> make[1]: *** [pylith] Error 2
> make[1]: Leaving directory `/home/ehsanhaghighat/
> development/pylith-gprs/build/pylith'
> make: *** [installed_pylith] Error 2
> ——
>
>
> First, my question is do you think it is doable at all? (I don’t see a
> reason to hold it back) Any suggestion you have to bypass this?
>
>
> Best regards,
> Ehsan
>
>
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20170703/86486cbe/attachment.html>