[CIG-SHORT] Pylith-output data of a specified fault node

[Charles Williams]

Dear Ge Li,

I believe that OutputSolnPoints will only provide solution variables (displacement, velocity).  If you want fault values you’ll need outputSolnSubset.  If it’s too much output to use the entire fault, it’s possible you could subdivide the fault and just output the part you want.  This may not work correctly, however, since you’ll need to provide fault edges for each subset.

If it’s not the amount of output that’s the problem, it should be easy to write a Python script to extract the vertex info you need from the fault output.  Also, I think there may be a way to do this in Paraview.

Cheers,
Charles


> On 30/10/2018, at 8:42 AM, Ge Li <ge.li2 at mail.mcgill.ca> wrote:
> 
> Hi all,
> 
> Is there any way to output data, i.e., traction, slip and slip rate of a specified fault node?
> The ‘OutputSolnPoints’ seems to only output displacement and velocity.
> 
> Thank you!
> 
> 
> Ge Li
> Ph.D. Candidate
> Earth & Planetary Science,
> McGill University
> 3450 University Street
> Montreal, QC, H3A 0E8
> 514-8399916
> 
> 
> _______________________________________________
> CIG-SHORT mailing list
> CIG-SHORT at geodynamics.org
> http://lists.geodynamics.org/cgi-bin/mailman/listinfo/cig-short

Charles Williams I Geodynamic Modeler
GNS Science I Te Pῡ Ao
1 Fairway Drive, Avalon 5010, PO Box 30368, Lower Hutt 5040, New Zealand
Ph 0064-4-570-4566 I Mob 0064-22-350-7326 I Fax 0064-4-570-4600
http://www.gns.cri.nz/ <http://www.gns.cri.nz/> I Email: C.Williams at gns.cri.nz <mailto:your.email at gns.cri.nz>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.geodynamics.org/pipermail/cig-short/attachments/20181030/3fadbaf2/attachment.html>